WCM-BT – Cold Pan
(Refrigerated – Air Flow System, with Evaporator; Non NSF-7)
The WCM-BT series cold pan is the most efficient refrigerated cold food display available anywhere. The traditional cold-wall system is replaced by a forced air evaporator, enabling precise temperature control and maximum cold transfer to your food product. The drop-in pan can be installed in virtually any counter and is fully self-contained—just plug it in and turn it on.
The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory-applied gasket so that it can be installed in the finest wood fixtures without marring the countertop. The pan is constructed of stainless steel and is provided with a 3/4″ stainless steel drain. The forced air evaporator drains into a condensate evaporator.
Features
- Forced air evaporator blower system for maximum efficiency in cooling—more consistent food product temperature
- Automatic Defrost System
- Fully insulated for maximum efficiency and energy saving
- Factory-applied gasket makes installation a snap and seals units to the countertop, thus eliminating seepage
- Accommodates standard 12″ x 20″ pans with the use of separator channel(s), or fractional size pans with the use of optional adapter bars
- 1-Year Parts & Labor Warranty
- UL Listed
Top
- Constructed of 18-gauge, type 304 stainless steel, die stamped with a raised perimeter bead.
- There shall be a solid vinyl gasket under the beaded edge to form a seal with the countertop, thus preventing seepage or marring of the countertop.
- Embossed mounting lugs are provided along the inner surface of the top to hold a full set of removable separator channels in place.
Liner
- The inner liner shall be 18-gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish.
- All corners are coved with a minimum 1/4″ radius.
- A 3/4″ diameter drain with strainer, 4″ PVC nipple, and valve is provided.
Insulation
- The pan is fully insulated with high density polystyrene, 1″ thick on all sides, 2″ thick on the bottom and enclosed with a 22-gauge galvanized steel outer case.
Refrigeration System
- The compressor housing shall be fabricated from 14-gauge galvanized angles and bolted to the base of the unit.
- A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control.
- The system is also provided with a forced air evaporator for even temperature throughout the pan that drains into a condensate evaporator pre-wired in the unit.
- Automatic defrost system is provided.
- The system is fully charged with CFC-free refrigerant and ready to operate.
Note
- Proper ventilation must be provided in counter.
Electrical
- The unit will be wired for 15-amp, 120-volt, single-phase operation with an on/off thermostat switch and pilot light.
- A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
Models
- WCM-BT-3
- WCM-BT-4
- WCM-BT-5
- WCM-BT-6
Resources
Certifications
Laminate Options
Explore more ways to customize and design the perfect fit for your operation.
