Mechanical

RML – Slim-Line Refrigerated Cold Pan

Find a Rep

Ask a Question

Find a Rep Ask a Question

RML slim-line recessed cold pan with self-contained refrigeration by Atlas Metal

(3″ Recessed Top; NSF-7)

The RML series refrigerated cold pan eliminates the mess and expense of ice in your cold food displays. The unit is used with standard 12″ x 20″ pans, and in the long configuration, the overall cold pan will require only 19-1/4″ of clear counter space.

The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory applied gasket so that it can be installed in the finest wood fixtures without marring the counter top. The pan is constructed of stainless steel and is provided with a 3/4″ stainless steel drain.

Features

Slim-line configuration—it can install in counter only 19-1/4″ wide
Fully insulated for maximum efficiency and energy savings
Factory-applied gasket—makes installation a snap and seals units to the countertop, thus eliminating seepage
The unit is used with standard 12″ x 20″ pans, and in the long configuration, the overall cold pan will require only 19-1/4″ of clear counter space.
NSF Certified; UL Listed
1-Year Parts & Labor Warranty

Top

Constructed of 18-gauge, type 304 stainless steel, die stamped with a raised perimeter bead.
There shall be a solid vinyl gasket under the beaded edge to form a seal with the countertop, thus preventing seepage or marring of the countertop.
Embossed mounting lugs are provided along the inner surface, 3″ down from the top, to hold the pan rails and a full set of removable separator channels in place.

Liner

The inner liner shall be 18-gauge, type 304 stainless steel with 3″ recessed top, one piece construction, all welded, ground and polished to a uniform finish.
All corners are coved with a minimum 1/4″ radius.
The liner has copper tubing firmly soldered to the top 3″ on all sides.
A 3/4″ diameter drain with strainer, 4″ PVC nipple, and valve is provided.

Insulation

The pan is fully insulated with high density polystyrene, 1″ thick on all sides, 2″ thick on the bottom and enclosed with a 22-gauge galvanized steel outer liner.

Refrigeration System

The compressor housing shall be fabricated from formed angles and bolted to the base of the unit.
A fully self-contained condensing unit is provided, with a hermetically sealed compressor and a thermostat control.
The system is fully charged with CFC-free refrigerant and ready to operate.

Note

Proper ventilation must be provided in counter.

Electrical

The unit will be wired for 15-amp, 120-volt, single-phase operation, with an on/off switch and pilot light.
A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.