Mechanical

WDF-L – Slim-Line Ice Cream Freezer

Find a Rep

Ask a Question

Find a Rep Ask a Question

WDF-L slim-line ice cream freezer with stainless steel insulated lid by Atlas Metal

(Refrigerated, Self-Contained)

The WDF-L series slim-line ice cream deep freezer lets you bring the profitability of reach-in ice cream service to your serving line. Ideal for ice cream or any frozen dessert, this drop-in can be installed in virtually any counter, as little as 16-1/2″ wide, and is fully self-contained—just plug it in and turn it on.

The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory-applied gasket so that it can be installed in the finest wood fixtures without marring the countertop. The interior is constructed of stainless steel and is provided with a 3/4″ stainless steel drain. The deep freeze is also perfect for a beer mug or salad plate chiller and can be specified with a Plexiglass lid.

Features

Slim-line configuration—it can install in counters only 16-1/2″ wide
Fully insulated for maximum efficiency and energy savings
Factory-applied gasket makes installation a snap and seals units to the countertop, thus eliminating seepage
Ideal for any frozen dessert or use it as a mug or plate chiller
1-Year Parts & Labor Warranty
NSF Certified and UL Listed

Top

Constructed of 18-gauge, type 304 stainless steel, die stamped with a raised perimeter bead.
There shall be a solid vinyl gasket under the beaded edge to form a seal with the countertop, thus preventing seepage or marring of the countertop.

Liner

The inner liner shall be 18-gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish.
All corners are coved with a minimum 1/4″ radius on the horizontal edges and a minimum 3/4″ radius on the vertical edges.
The liner has copper tubing firmly soldered to the exterior sides and bottom.
The unit is provided with an all-stainless-steel, insulated, hinged, lift-off lid, with plastic coated pulls.

Insulation

The unit is fully insulated with high density polystyrene, 2-1/2″ thick on all sides, and enclosed with a 22-gauge galvanized steel outer liner.

Refrigeration System

The compressor housing shall be fabricated from formed angles and bolted to the base of the unit.
A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control.
The system is fully charged with CFC-free refrigerant and ready to operate.

Note

Proper ventilation must be provided in counter.

Electrical

The unit will be wired for 15-amp, 120-volt, single-phase operation, with an on/off thermostat switch and pilot light.
A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.