Mechanical

WF – Frost Top

Find a Rep

Ask a Question

Find a Rep Ask a Question

(Refrigerated Frost Top)

The WF series frost top provides the most attractive way of displaying your pre-plated cold foods. The unit frosts over quickly, providing a bed of snow—the perfect setting for salads and desserts. The drop-in pan can be installed in virtually any counter and is available as either a fully self-contained unit—just plug it in and turn it on—or as a remote unit when the compressor must be located in a different location.

The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory-applied gasket so that it can be installed in the finest wood fixtures without marring the countertop. The frost top is constructed of stainless steel and stands 1″ above the countertop for an eye-catching display. When turned off, the condensate melts into the full perimeter gutter, sloped to a 1/2″ drain.

Features

“Quick,” frost top, stands 1″ above counter for attractive display—ideal for pre-plated cold food
Fully insulated for maximum efficiency and energy savings
Factory-applied gasket makes installation a snap and seals units to the countertop, thus eliminating seepage
1-Year Parts & Labor Warranty
NSF Certified and UL Listed

Top

Constructed of 14-gauge, type 304 stainless steel, die stamped with a raised perimeter bead.
There shall be a solid vinyl gasket under the beaded edge to form a seal with the countertop, thus preventing seepage or marring of the countertop.

Frost Top

Constructed of 14-gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish.
The top is formed to stand 1″ above the countertop and is provided with a 1/2″ full perimeter gutter to collect melted condensate; a 1″ IPS drain is provided.
The frost top has copper tubing firmly soldered to the exterior bottom.

Insulation

The pan is fully insulated with high density fiberglass and polystyrene, 1-1/2″ thick, and enclosed with an 18-gauge galvanized steel outer liner.
The entire unit is removable without the use of tools.

Refrigeration Series (WCM Series Only)

The compressor housing shall be fabricated from 14-gauge galvanized angles and bolted to the base of the unit.
A fully self-contained condensing unit provided with a hermetically sealed compressor.
The system is fully charged with CFC-free refrigerant cap tube, filter drier, and on/off switch provided—and ready to operate.

Note

Proper ventilation must be provided in counter.

Electrical (WF Series Only)

The unit will be wired for 15-amp, 120-volt, single-phase operation with an on/off switch and pilot light.
A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.