Mechanical

INFDF – Refrigerated Serving Units

Find a Rep

Ask a Question

Find a Rep Ask a Question

(Ice Cream Freezer)

With striking, yet highly durable features like 16-gauge stainless steel tops and “locking horn” technology, INFINITI FIT is built to evolve with your operation. Choose and customize what you need now, and then easily add it later.

Features

Fully insulated for maximum efficiency and energy savings.
Self-contained refrigeration system – just plug it in and turn it on.
Positive self-locking device – keeps tops level and equipment in place.
Fully mobile – each unit is provided with 5” diameter swivel casters two with brakes.
Versatile – available in a wide range of sizes and a wide variety of finishes and colors.
NSF Approved, UL Listed

Top

Constructed of 16-gauge, type 304 stainless steel, die-formed, welded, ground and polished.
The top is provided with an opening to receive the appropriately sized drop-in unit.

Body

Frame construction shall be of hi-tensile stainless steel square tubing, 1-1/4″ x 1-1/4″.
Frame sections are welded construction, ground and polished to a uniform finish.
Body and panel is constructed from 18-gauge stainless steel with 1/16” thick plastic laminate front and ends.
Rear aprons is constructed front 16-gauge stainless steel with 1/16” thick plastic laminate finish.
Owner to specify finish.
An integral locking device shall be provided to align and retain cart positioning when two or more carts are joined.

Deep Freeze Container

The cart includes a WDF series built-in deep freezer installed in the top.
Constructed of 18-gauge, type 304 stain-less steel, with raised perimeter bead and solid vinyl gasket.
The unit is fully insulated with 2-1/2″ of high density polystyrene on all sides and enclosed with a 22-gauge galvanized steel outer case.
The inner liner has copper tubing firmly soldered to the exterior sides and bottom.
The unit is provided with a double pan, insulated lid with a rubber, self-insulating hinge.
The entire lid is removable.

Refrigeration System

The compressor housing shall be fabricated from formed 14-gauge galvanized angles and bolted to the base of the unit.
A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control.
The system is fully charged with CFC-free refrigerant and ready to operate.

Electrical

The unit will be wired for 15-amp, 120-volt, single-phase operation with an on/off switch and pilot light.
A 6′ long, 3-wire cord and plug (NEMA 5-15P) will be provided.

Casters

The casters shall be 4” diameter, non-marking rubber tired, swivel type with ball bearings in both swivel and axle raceways, provided with grease fittings.
Both casters on operator’s side have toe activated brakes.